We’ve had a lot of requests in the comments for more Arduino centered posts so we were happy when [Njay] told us about his EDuino board. This is a minimal Arduino clone that has a crystal and it’s capacitors, a pull-up resistor and button on the reset pin, and a detachable serial programming connection. He also has a breadboard-friendly version seen above with all the interface pins on one side of the board. This is certainly a useful project and we’re glad to see the board files available for download. This does get us thinking… is this an Arduino,…
Hack
EDuino – Arduino or AVR breakout?
Hack
Parts: 4×20 VFD character display (NA204SD02)
Futaba makes vacuum florescent character displays that can be used as a drop-in replacement for common character LCDs. VFDs have a wider viewing angle, and generally look cooler.
Futaba’s character displays can be interfaced using the standard 8-bit or 4-bit parallel LCD interface, or a simple two-wire protocol. The protocol type is set by resistors on the back of the display, so it’s not particularly easy to change without a hot-air rework station. Today we’ll demonstrate a serially-interfaced VFD using the Bus Pirate.
Futuba VFD character LCD replacement (NA204SD02, $7.00). Datasheet (PDF).
VFD (pin #)
Bus Pirate
GND (1)…
Hack
Mixed voltage interfacing with the Bus Pirate
Most of the parts we use operate at 3.3volts, but we still run into a lot of old 5volt stuff, and an occasional 2.5volt or 1.8volt part. This post explains how to use the Bus Pirate’s open collector pin mode to interface with parts at different voltages.
We’ve got more details and some example scenarios below the break. Yup, this is another Bus Pirate post. It’ll all be over soon though, because there’s a few days left to get your own Bus Pirate for $30, fully assembled and shipped worldwide.
Overview
The Bus Pirate has a normal pin mode…
Hack
Parts: ShiftBrite RGB LED module (A6281)
Macetech’s ShiftBrite is a high-power RGB LED coupled with an Allegro A6281 backpack. The A6281 uses three 10bit pulse-width modulators to mix millions of colors using the red, green, and blue elements in the RGB LED. Multiple modules can be chained together for bigger projects, like the ShiftBrite table.
Below the break we demonstrate a ShiftBrite module using the Bus Pirate. For a limited time you can get your own Bus Pirate, fully assembled and shipped worldwide, for only $30.
ShiftBrite RGB LED module (Macetech, $4.99). ShiftBrite datasheet and example code, Allegro A6281 datasheet (PDF).
The ShiftBrite module is…
